NM-1A-OC3MM |
|
Product name:NM-1A-OC3MM |
|
Item:CISCO |
|
←[Previous:CISCO] [Next:CISCO]→ | |
Details: |
|
Technical Information
Application/Usage: Data Networking
Interfaces/Ports
Interfaces/Ports: 1 x OC-3c/STM-1 WAN
Interfaces/Ports Details: 1 x SC Duplex OC-3c/STM-1 WAN
Media & Performance
Connectivity Media: Multi-mode Fiber OC-3c/STM-1
Distance Supported: 1.24 Mile Multi-mode Fiber
Data Transfer Rate: 155 Mbps OC-3c/STM-1
Management & Protocols
Management:
CiscoWorks2000 and CiscoWorks network management integration
Enhanced setup configuration
Text-based command-line interface (CLI)
Controls/Indicators
Status Indicators:
Enabled - Network module is seated correctly and is communicating to the bus
RCLK - Carrier detect
FERF - Far end Rx failure
OOF - Out of frame error condition
AIS - Alarm indication
Miscellaneous
Additional Information:
ATM Edge Connectivity
LAN-to-LAN Routing
Serial & Legacy Concentration
VPN & Firewall Solutions
Voice & Fax Integration
Support SDH G.707 and G.708 specifications
The Cisco 3620 and 3640 will not support full 155-Mbps OC-3 line rates. The actual maximum supported speed ranges between 20 and 80 Mbps, depending on packet size
RFC 1483 support for multiple encapsulations over ATM
RFC 1577 support for routing over ATM
ATM service classes: UBR, UBR+, VBR-rt, VBR-nrt, ABR, and CBR (data only)
ATM Forum UNI 3.0, UNI 3.1, and UNI 4.0
AAL5 ATM adaptation layer
Up to 1024 simultaneous Virtual Circuits (VCs)
Layer 2 per-VC queuing and traffic shaping
ATM PVCs and SVCs
Permanent Virtual Paths (PVPs) (up to three)
LANE 2.0 client and server
F4 and F5 Operations and Maintenance (OAM) cell support
ABR SVCs
MPOA client and server
Tag Switching (MPLS when approved)
IETF PPP over ATM
Next Hop Resolution Protocol (NHRP)
ATM bandwidth (resource) manager
Interim Local Management Interface (ILMI)
ATM UNI 4.0 traffic management
Frame User to Network Interface (FUNI)
ATM Traffic-Shaping Feature:
Advanced Bandwidth Management Feature
ATM Layer Management
System Requirements:
Maximum recommended on a single Cisco 3640 and Cisco 3620 is one
Max two high-speed network modules in a Cisco 3640 (includes Fast Ethernet, ATM, HSSI)
Requires Plus feature sets of Cisco IOS Release 12.0(3)T or above
Compatibility:
Cisco 3620
Cisco 3640
Supported Platforms & Minimum IOS Versions:
3725 - 12.2(13)T
3660 series - 12.0(5)T
3640 - 12.0(3)T
3620 - 12.0(3)T
Certifications & Standards:
ATM Standards Supported:
Multiprotocol encapsulation with support for Logical Link Control/Subnetwork Access Protocol (LLC/SNAP) encapsulation and VC multiplexing (Internet Engineering Task Force [IETF] RFC 1483)
Classical IP and Address Resolution Protocol (ARP) over ATM; client and ARP server (IETF RFC 1577; IETF RFC 1755; IETF RFC 1626)
MPOA for IP, Novell IPX, DECnet, AppleTalk Phases 1 and 2, Connectionless Network Service (CLNS), Xerox Network Systems (XNS), and Banyan VINES via IETF RFC 1483
ATM Forum LAN Emulation (LANE) including LEC, BUS, LES, and LECS
IETF PPP over ATM
MPOA
Tag Switching/MPLS (when approved)
Network Management:
MIB II
Synchronous Optical Network (SONET) MIB
ATM MIB
ATM ILMI MIB
LANE MIB
RFC 406, 1595, 1695, and 2233
IEEE:
IEEE 802.6
Warranty
Limited Warranty: 90
|
Related Products : |
|
|
|
|
||||||||
|
|
|
|